Silicone Transfer by Hotmelt Powder

silicone transfer stickers by hot melt powder

Silicone ink PET films:

Two types : one is glossy coating film which will be glossy after heating press on fabric ,another one is matte finish effect after heating press on fabric.

Mesh number： 120-200 , Mesh(screen film )thickness 0.1-0.2MM,it is depends on printing Artworks.

Squeegee：65-80 degree .

Printing tips:

1 Silicone ink color layer printing for 3-4 layers  :

Silicone ink     XG-866A-2Y       100G

Pigments or special powders       10-20G  (10-20% white&fluorescent 15-20% other colors 10%)

 Catalyst     XG-866B-2           2G   2%

Thinner        XG-128AH          10-20G    10-20%

Flash by 100 to120 degree.

2 Silicone ink clear layer printing 2 -4 layers if needed for high density stickers,if need more high density then print more times clear.

  Silicone ink     XG-866A-2Y     100G

 Catalyst     XG-866B-2           2G   2%

Thinner        XG-128AH          10-20G    10-20%

Flash by 100 to120 degree.

3 Transparent silicone with catalyst and adhesion agent with harder layer printing:

1). Silicone ink          XG-866A-2Y       100G

   Catalyst               XG-866B-2       1- 2G  1- 2%

2). Adhesion agent         XG-180A       50G

Adhesion agent harder   XG-180B       5G    10%

Mixing together for printing :Adhesion according to silicone is 50%. Adhesion harder can get silicone ink dry, so to get longer printing can get silicone catalyst mixing ratio 1% or  use adhesion agent harder only no need silicone catalyst.

 Printing wet on wet for 2 times， keep 100% wet can not heat:

4 Spill hot melt powder on wet silicone and adhesion agent layer immediately.

 5 After finish, to put into the oven to bake by 100-120 degree for about 10 minutes,if bake higher temp then less time,once hot melt powder 100% melt then it is ok.

Press the stick on the heat transfer press machine by the temp of 160-170 degree for 10-16 seconds with pressure of 4KG.

 Cell:+86 15899645234    Email:ceo@xgsilicone.com